Woodpeckers USPMD Ultra-Shear Pen Mandrel System (#2 Morse Taper)

Product Summary

Ultra-Shear Pen Mandrel System and Precision Pen Turning Bushings 

Let’s start at the headstock side. The mandrel shaft slides into a 12-segment collet. Expose just the amount you need and close the collet with the locking collar. The shaft is perfectly centered and locked securely.

The ground and polished mandrel shaft accommodates almost all bushings on the market, including our new precision bushings (more on them later).

On the tailstock side, the mandrel shaft goes into another 12-segment collet…don’t worry about putting in extra spacers to take up the unused shaft, just slide your tailstock right up tight to your work. As you tighten your tailstock, the cap compresses the collet, centering the mandrel shaft perfectly.

While we were designing the world’s best pen mandrel, we decided to make the world’s best bushings to go along with it. Ultra-Shear Precision Pen Bushings are more durable and fit the mandrel shaft and the tube diameter better than any others out there and match the pen kit specs for outside diameter to the strictest tolerance. Unlike ordinary bushings, Ultra-Shear Precision Pen Bushings are turned from 4140 ChroMoly steel, the same tough material used in engine crankshafts. Each bushing is engraved with its part number so you won’t have to guess about which bushing goes with what kit. The portion that fits inside the pen blank is longer, providing additional support, and the bushings for two-piece pens are clearly marked to mate up with your blanks correctly.

We also turned a wear groove in the bushing just back from where it enters the pen blank. As long as you can see that groove, your bushing isn’t worn out and will give you perfect alignment of the turned pen to the kit components. After a mountain of finished pens, when the wear groove is gone, you’ll know it’s time to get a new bushing set.

You won’t find another mandrel on the market that centers your work more precisely. Every piece of the system is manufactured to the strictest tolerances, from the finest materials available, on state-of-the-art CNC Swiss Lathes.

If youve turned more than a couple pens, youve probably noticed that theres just not much material left on top of the brass tube when you get finished. Any amount of misalignment can show up as brass showing through acrylic or even worse, a complete blow-out. None of the mandrels available on the market today seem to help matters much, until now. Introducing the Ultra-Shear Pen Mandrel System. Each component is designed and manufactured with one goalkeeping your pen perfectly centered on your lathe.